Touch Operating Module - Basic State; Led Indicators; Buzzer Function - Honeywell 013002 Bedienungsanleitung

Operating Manual Touch operating module for MB/MB-Secure
4.

Touch operating module - basic state

arming not possible
End
18. April 2013
In the basic state (without impending fault or triggered detector group), the backlighting is deactivated
and the screen is dark or the slideshow function is activated and switched on. In case of alarm, the
display is activated to achieve a better signalling effect. The operator guidance and message display
appear in plain text.
After touching the screen the current time is displayed. At the top the message "arming not possible" or
"Ready for internal arming" appears. With key "End" the backlighting is deactivated again or the
slideshow is switched on.
If there are no further entries during operation, the display switches to the basic state or to the
slideshow. If the slideshow is switched off the display illumination will be deactivated according to the
programmed operating time. Touch the screen with a finger to reactivate the display illumination.
4.1

LED indicators

LED red lights up: Intrusion alarm
LED red flashes: Tamper or hold-up alarm
LED green lights up: Unit ready for operation
LED green flashes: Unit
LED yellow lights up: General fault of central control panel
LED yellow flashes: Mains fault of central control panel
4.2

Buzzer function

Buzzler, activated
17:10:24
not ready for operation
- when switch-on delay is active
- in case of internal alarm (time limited)
- in case of tamper alarm or fault until manually stopped
- after external disarming
- when clearing (system reset), walk test on
- when touching the screen as acknowledgement signal
- with door interlock function when arming and disarming
- with reminder signal after alarm and external disarming
- in case of faults
- Additional functions programmable by installer
(output programming)
Ready for internal
arming
17:10:24
End
18. April 2013
21