Linea 2000 DOMO DO1084S Gebrauchsanleitung Seite 29

PLEASE NOTE:
· Make sure that all components are correctly assembled before using the vacuum cleaner again.
· Always use the vacuum cleaner with the filters intact. If you do not do this, you may lose suction force
or damage the motor.
· Unplug the plug before cleaning the filters.
· Do not put the filter into the dishwasher.
· Do not use a hairdryer to dry the filters.
FREQUENTLY ASKED QUESTIONS
Problem Cause
The appliance The appliance is not
does not start. plugged in.
The appliance is not turned on.
The appliance The appliance has overheated,
stops working. so the safety was tripped. This
can be caused by dirty filters or a
blockage.
The suction is The appliance is not correctly
too weak. assembled, so the suction is
being lost.
The dust reservoir is full.
The hose is clogged.
The filters are dirty.
The valve on the handle of the
hose is open.
The filters are congested.
There is a The appliance is overheated.
burning smell
from the
appliance.
The red The filters are dirty or the hose
light on the is clogged.
back of the
appliance lights
up.
www.domo-elektro.be
Solution
Put the plug in the socket.
Press the on/off switch.
Allow the appliance to cool completely. When the
appliance has cooled down, it will function again.
Clean the filters and check that the hose is not
clogged.
Check that everything is assembled correctly.
Remove all of the accessories and then replace
them step by step in their place.
Empty the dust reservoir and make sure that it
does not exceed the maximum level.
Insert the hose in the reverse manner (with the
handle) in the suction opening of the appliance.
The clog will be suctioned to the other side,
which will free the hose.
Carefully clean the filters as described in this
manual. It is very important that you already
thoroughly clean the filters.
Close the valve.
Over time, the pores in the filters will become
congested. Replace the filters.
Immediately switch off the appliance and let the
appliance cool down. Clean the dust reservoir and
the filters.
Clean the filters and make sure that you remove
the clog. Always pick up all large objects before
you start to vacuum.
29
DO1084S