Nikon E2N Bedienungsanleitung Seite 7

Setting the six basic modes simultaneously
(Page 45)
-Command lock is cancelled. (See page 46.)
*
-Command lock (see page 46) and preview mode (see page 8 on this manual) are
canceled.
External synchro-flash shooting
(Page 62)
3
Depress the shutter release button .
The "Sy" mark blinks in the LCD panel to
indicate that the camera is in standby mode;
pictures are taken in sync with the firing of the
remote speed light
- The standby mode will be canceled approx.
10 seconds after depressing the shutter
release button if the firing of the remote
speedlight is not detected by the camera.
3 Depress the shutter release button .
The "Sy" mark blinks in the LCD panel to
indicate that the camera is in standby mode;
pictures are taken in sync with the firing of the
remote speed light.
-The standby mode will be canceled approx.
2 minutes after depressing the shutter
release button if the firing of the remote
speedlight is not detected by the camera.
-To cancel the standby mode, rotate the
Main dial to L and turn the power OFF. Note
that the mirror remains in the up position
throughout. Set the Main dial to L and turn
the power ON again to bring the mirror back
down.
7