Werbung
Verfügbare Sprachen
Verfügbare Sprachen
iCOOL 1200
Tab. 2
Max. coolant outgoing pressure/pump pressure
Power supply
Rated frequency
Fuse protection
Connection type
Number of connections
Dimensions (L × W × H)
Weight
Protection type
5 Transport and installation
The unit is transported and installed in conjunction with the welding power source.
► Observe the operating instructions for the welding power source.
6 Commissioning
Electric shock due to defective cables
Damaged or improperly installed cables can lead to fatal electric shock.
► Check all live cables and connections for proper installation and damage.
► Damaged, deformed or worn parts should only be replaced by a qualified electrician.
NOTICE
Material damage due to contaminated coolant
Contamination in the coolant can lead to damage and increased wear in the device.
► Keep the cap on the coolant tank closed.
NOTICE
Material damage due to a lack of coolant
If there is insufficient coolant, the device's pump can overheat and cause irreparable damage.
► Ensure that coolant is added to the device before commissioning it.
► Ensure that the device is bled during commissioning.
► Ensure that the pump does not run dry.
► Observe the fill level indicator on the device.
NOTICE
Material damage when bridging multiple devices
The use of several devices (in sequence or in parallel) can result in material damage.
► Do not bridge the device with other cooling units.
6.1 Fuse protection for the device
► Protect the device with a 1A fuse (5 × 20 mm).
General information
WARNING
5 Transport and installation
3.5 bar – 0.35 MPa
400 V ±10%
50 Hz
1 A; delay-action
Quick lock
2 front, 2 rear
760 mm × 390 mm × 210 mm
31 kg
IP23 S
EN - 7
Werbung
