Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2 Safety
2 Safety
This chapter warns of residual hazards that should be kept in mind to operate the product safely.
Non-observance of the safety instructions may result in risks to the life and health of personnel, and
environmental damage or material damage.
► Observe the document entitled "Safety Instructions".
► Observe the safety data sheet for the coolant.
2.1 Designated use
The device described in these operating instructions may be used only for the purpose and in the manner
described in these operating instructions. The cooling unit is used to cool liquid-cooled welding torches.
Any other use is considered improper. Unauthorized modifications or changes to enhance the performance
are not permitted.
► Do not exceed the maximum load data as defined by the documentation supplied. Excessive loads lead
to irreparable damage.
► Do not make any constructive changes to this product.
► Do not use or store the device outdoors where it is wet.
2.2 Obligations of the operator
► Ensure that only qualified personnel are permitted to perform work on the device or system.
Authorized personnel are:
— those who are familiar with the basic regulations on occupational safety and accident prevention;
— those who have been instructed on how to handle the device;
— those who have read and understood these operating instructions;
— those who have been trained accordingly;
— those who are able to recognize possible risks because of their special training, knowledge, and
► Keep untrained persons out of the work area.
2.3 Warning and notice signs
The following warning, notice and mandatory signs can be found on the product:
These markings must always be legible. They may not be covered, obscured, painted over, or removed.
2.4 Personal protective equipment
► Wear your personal protective equipment (PPE).
► Ensure that others in close proximity are also wearing personal protective equipment.
Personal protective equipment consists of protective clothing, safety goggles, protective gloves,
and safety shoes.
2.5 Emergency information
In the event of an emergency, immediately disconnect the following supplies: electrical power supply.
EN - 4
experience.
► Read and observe the operating instructions.
Electrical voltage caution. Danger of electric shock.
► Only a trained electrician should open the device.
► Interrupt the electrical power supply before opening the device.
Warning against hot surfaces. Risk of burns.
► Do not touch hot surfaces.
► Wear protective gloves.
iCOOL 1200
Werbung
