Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
POWER ON THE LASER
Set the ON/OFF knob to position „ON" . The
instrument is now ready for use (the ON/OFF LED
is illuminated). An audible and optical (blinking
lines) alarm indicates if the instrument was set up
outside of the compensator range. If so, set up the
instrument on a more even surface.
To power off the instrument bring the ON/OFF
knob in position „OFF" . The instrument is now
powered off and the compensator is blocked to
avoid damages during transport.
NOTE: During transport the ON/OFF knob (compensator clamp) must be set to „OFF" .
Disregard may lead to damages of the compensator.
RECEIVER / MANUAL FUNCTION
The instrument is powered off (OFF position).
Press the button RECEIVER MODE / MANUAL
FUNCTION once to enter into the MANUAL
function. The MANUAL LED is illuminated. Now
the required laser lines can be projected and the
instrument can be used in slope position.
Press this button again to power on the receiver function. The receiving LED is illuminated. Now the
receiver FR 57-TR can detect the laser lines projected from the instrument.
Press the button once more in order to power off the instrument.
FOLLOWING LASER LINES CAN BE PROJECTED:
H
V1
V2
H
V1
V2
23
Werbung
