Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Switch off the motor before you carry out any
inspections of the blade. Remember than the
blade will continue to turn for a few seconds after
the motor has been switched off. Never
attempt to stop the blade.
Check regularly that the blade is correctly secured,
in good condition and well ground. If not,
grind or replace the blade. If the moving blade
strikes an object, stop the mower and wait until
the blade has come to a complete standstill. Then
check the condition of the blade and the
blade holder. If they are damaged, they must be
replaced.
Place the mains lead in loops on the ground in front
of the socket. Mow away from the socket
and cable and ensure that the mains lead is always
on the section of lawn that you have already mowed
so that you do not run over the mains lead with the
mower. As soon as you see mown grass on the
lawn whilst you are mowing, the grass bag will need
emptying.
CLEANING AND MAINTENANCE
Before performing any work
on the equipment, pull out
> Cleaning
§ Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it with
compressed air at low pressure.
§ We recommend that you clean the device
immediately each time you have finished using it.
§ Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the
device.
Never use solvents such as
petrol, alcohol, ammonia
water, etc. These solvents
may damage the plastic
> Blade maintenance
§ Regularly remove grass and dirt from the blade.
§ At the beginning of the gardening season,
carefully examine the condition of the blade.
§ If the blade is very blunt, sharpen or replace the
blade.
§ If the blade is damaged or worn, fit a new blade.
Attention!
the power plug.
parts.
Warning!
Observe the following
precautions:
§ Disconnect the mower from the mains and wait
until the blade has stopped rotating before
proceeding.
§ Be careful not to cut yourself. Use heavy-duty
gloves or a cloth to grip the blade.
§ Only use the specified replacement blade.
§ Do not remove the impeller (A)for any reason.
> Replacing the blade
For safety reasons, we recommend having the
blade replaced by an authorized professional.
Replacement blade, as this will ensure top
performance and safety under all conditions. Carry
out the following steps to change the blade:
§ Turn the mower onto its side.
§ Grip the blade( C) with one hand.
§ Use a wrench (not supplied) to loosen and remove
the blade nut (B).
§ Replace the blade
§ Securely tighten the blade nut.
STORAGE
Always clean your mower before storage. Store
your mower in a clean, dry environment.
To avoid mould on remaining contents, make sure
the grass collect bag is empty and dry.
You can fold the handle to save space, loosen the 2
clamps on each side of the handle and
bend the upper handle part towards the front of the
machine.
> Long-term storage:
Apply eco-friendly oil to the mower blade to keep it
from rusting.
> Wintering
Have your blade sharpened after the mowing
season, so the machine is ready for the new
season.
TECHNICAL DATA
Rated Voltage
Rated Frequency
Rated Power
Rotation speed
Cutting width
Blade
Protection class
Int. protection degree
Collect box / bag
Cutting heights
Induction motor
«
Fig E »
Important: Wear work
gloves!
230-240 V
50Hz
1400W
3800 min
-1
34 cm
32310051
Class II
IPX4
25 L
25/37/50/63/75mm
No
52
Werbung
