Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The cutting height can be adjusted from
25 mm - 75 mm.
▪ For a higher blade height, grasp the height
adjustment lever and move it towards the rear of the
mower.
▪ For a lower blade height, grasp the height
adjustment lever and move it towards the front of
the mower.
Select the cutting height corresponding to the
desired grass height. If necessary, mow several
layers to mow a maximum lawn height of 75mm in
one pass.
Be sure to avoid aisles, which may impede the free
movement of the extension cord.
Empty the grass catcher when it is full, so as not to
block the discharge opening. To avoid clogging the
discharge opening and unnecessary motor
overload, be sure not to step over freshly cut grass
left where you have already mowed.
We recommend using your trimmer as described
below for best results and to reduce the risk of
cutting the power cord.
> 5 Cutting height positions
I
25mm
II
37mm
III
50mm
IV
63mm
V
75mm
§ 25 mm (lowest cutting height position)
~
§ 75 mm (highest cutting height position)
OPERATION «
> Connect to power supply.
Before you connect the equipment to the mains
supply make sure that the data on the rating
plate are identical to the mains data.
Connect the plug to an extension cable. It is
imperative to secure the extension cable with the
cable grip.
«
> Starting
Fig D »
Press and hold safety button (A) (then squeeze the
switch lever (B) towards the handle).
Release the safety button.
> Stopping
Release the switch lever.
After switching off, the
cutting blade will go on
turning for a few seconds,
make sure the blade has
Fig B & D »
«
Fig B »
ATTENTION :
Do not rapidly switch off
> Safety button
Important! To prevent the machine switching on
accidentally, the lawn mower is equipped with
a safety lock-off which must be pressed before the
switching bar can be activated. The lawn mower
switches itself off when the switch is released.
Repeat this process several times so that you are
sure that the machine functions properly.
Before you perform any repair or maintenance work
on the machine, ensure that the blade is not rotating
and that the power supply is disconnected.
Never open the discharge
flap if the grass bag is being
emptied and the motor is
still running. The rotating
blade can cause serious
Always secure the discharge flap and grass bag
carefully. Always switch off the motor before
you remove these items.
The safety distance between the blade casing and
the user provided by the guide struts must be
maintained at all times.
> Information on correct mowing
We recommend that you mow in overlapping lines.
Only mow with sharp, perfect blades so
that the blades of grass do not fray, making the lawn
turn yellow.
The cutting height should be between 4 and 6 cm
and the growth before the next cut should be
between 4 and 5 cm. If the lawn grows longer than
this on occasion, do not make the mistake of cutting
to normal length straight away since this will
damage the lawn.
Never cut the grass by more than half its height.
Keep the underside of the mower casing clean and
remove all grass deposits from it. Deposits make it
more difficult to start the mower and also adversely
affect the mowing quality and the grass discharge.
On slopes mow across the slope (not in up or down
direction).You can counteract the tendency of the
mower to slide down the slope by setting it at an
angle upwards.
that you do not remove more than 4 cm of grass
length in any one pass.
come to a complete
standstill.
CAUTION:
and on.
Important!
injuries.
51
Werbung
