Herunterladen Diese Seite drucken

Sanitas SWB 20 Gebrauchsanweisung Seite 12

Vorschau ausblenden Andere Handbücher für SWB 20:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
If the mains connection cable of this heated underblanket is damaged,
it must be disposed of. If it cannot be removed, the heated underblan-
ket must be disposed of.
Do not expose control and cables to direct sunlight.
When this heated underblanket is switched on:
– Do not place any sharp objects on it
– Do not place any heat sources, such as hot water bottles, heat
pads or similar, on it
The electronic components in the control warm up when the heated
underblanket is in use. For this reason, the control must never be cov-
ered or placed on the heated underblanket when it is in use.
It is essential to observe the information relating to the following chap-
ters: Operation, Cleaning and maintenance, Storage.
If you should have any questions about using our devices, please
contact our Customer Services department.
3. Intended use
CAUTION
This heated underblanket is designed for warming beds, only.
4. Operation
4.1 Safety
CAUTION
• This heated underblanket is equipped with a SAFETY SYSTEM. This sensor technology prevents the
entire surface of the heated underblanket from overheating by automatically switching off the heated
underblanket in the event of a fault. If the safety system has switched off the heated underblanket, the
temperature setting is not illuminated any more even when the heated underblanket is switched on.
• Please note that the heated underblanket is not operable any more due to safety reasons in this
case and has to be sent to the service address indicated.
• Do not connect the defective heated underblanket with another control of the same type. This would
trigger a permanent switch-off via the control's safety system.
4.2 Putting into operation
This heated underblanket must be fixed onto the mattress.
1. Leave space for the pillow and place the heated underblanket on the
mattress with the plug-in connector facing the pillow. Here, the plug-in
connector is located on the underside of the heated underblanket.
2. Stretch all of the elastic straps over the corners of the mattress. All 4
corners of the heated underblanket are then fixed onto the mattress.
CAUTION
Regularly check the position of the heated underblanket on the mattress.
The heated underblanket must never be used if it is folded.
12

Werbung

loading