Telwin DRIVE 1500 Bedienungsanleitung Seite 4

INSTRUCTION MANUAL
WARNING: READ
MANUAL CAREFULLY BEFORE USING THE
STARTER!
1. GENERAL SAFETY USER INSTRUCTIONS
FOR THIS STARTER
In order to reduce the risk of personal
injury and damage to equipment, it is
highly recommended to comply with all
essential safety measures and precautions
when using the starter.
Inexperience and untrained
-
people should be properly
instructed before using the
appliance.
- This appliance can be used by children
aged from 8 years and above and persons
with reduced physical, sensory or mental
capabilities or lack of experience and
knowledge if they have been given
supervision or instruction concerning
use of the appliance in a safe way and
understand the hazards involved.
- Children shall not play with the
appliance.
- Cleaning and user maintenance shall
not be made by children without
supervision.
- Protect the eyes. Always wear
protective goggles when using
acid lead accumulators.
- Avoid contact with battery acid.
If an operator should be sprayed
or come into contact with the
acid, rinse the relative parts immediately
under clean running water. Continue to
rinse the area until the physician arrives.
- It is important to connect the
cables with the poles in the right
direction:
First connect the red clamp to the positive
terminal on the vehicle battery (+ symbol).
Connect the black clamp to the vehicle
chassis, at a distance from the battery and
the fuel pipe.
- Use the starter in well ventilated areas.
Do not attempt to use the starter when
there is gas or inflammable liquids in the
vicinity.
- Make sure that the black and red clamps
never come into contact with each other
as this could cause them to fuse together
or with other metal objects. Return the
clamps to their respective housing.
(EN)
THE INSTRUCTION
- FOR 12 VOLT SYSTEMS ONLY! This device is
destined for use on vehicles running on 12
Volt electrical systems only.
- USE IN EMERGENCY SITUATIONS ONLY: do
not use the starter instead of the vehicle
battery. Use it during start-up operations
only.
- Do not work alone. If there is an accident,
the assistant can be of aid to the operator.
- Prevent electrical shocks. Be
very cautious when applying
the clamps to non-insulated
conductors or bus bars. Avoid all body
contact with surfaces of tubes, radiators,
and metal power substations whilst testing
the voltage.
- Keep the work area clean at all times. Untidy
cumbersome areas can lead to injuries.
- Protect the starter appropriately from all
possible damage. It must only be used as
indicated in this Instruction Manual.
- Ensure compliance with the indications
in the work area. Do not use in humid or
wet facilities. Never leave it out in the rain.
Always work in well lit areas.
- Always wear suitable clothing.
Never wear baggy clothing or
jewellery that can get caught
up in moving
operations, the use of electrically
insulated protection clothing and non-
slip boots must be worn at all times.
Persons with long hair must tie it back
and wear a hair net.
- Only experts are allowed to do repair work
on the starter as it involves significant risk
levels for inexperienced workers.
- Replacing parts and accessories. When
performing
replace with identical spare parts only. Use
of non-original spare parts invalidates all
warranties.
- Make sure that the device is always
positioned in a stable and well supported
manner.
Never climb over cables or electrical
structures.
- Careful attention must be paid during
maintaining work on the starter. Check the
condition of cables on a regular basis and
if any damage is detected, have the same
repaired by an authorised and qualified
technician.
- Check there are no damaged parts. Before
using this starter, carefully check that all
seemingly damaged parts and assess
whether or not they can operate correctly.
Check that the cables are securely fastened
to the starter. Remember that only
authorised and qualified technicians are
- 4 -
parts. During
maintenance operations,
all