Zibro SC 1832 Installations-Handbuch Seite 64

instal_SC1832.qxd 06-05-2010
INDOOR UNIT INSTALLATION
1. Fit the Installation Plate
1. Fit the installation plate
tion plate.
2. If the wall is made of brick, concrete or the like, drill eight (8) 5mm diameter holes in the wall. Insert
Clip anchor
3. Fit the installation plate
90
NOTE
90
Fit the Installation Plate and drill holes in the wall according to the wall structure and
corresponding mounting points on the installation plate. (Dimensions are in "mm" unless
otherwise stated)
40
40
133
Over 12 cm from the wall
133
Left rear side refrigerant
pipe hole Ø
4
64
10:55 Pagina 64
Correct orientation
of Installation Plate
Fig. 4
horizontally on structural parts of the wall with spaces around the installa-
for appropriate mounting screws
on the wall with eight (8) type "A" screws
70 70
750
70 70
750
150 mm or more to ceiling
Indoor unit outline
920
920
≥85
A:780 (<4.6 kW model), 920 (≥4.6 kW model)
Wall
Indoor
≥5°
Fig. 6
.
Installation plate
50
50
Fig. 5
Outdoor
.
Over 12 cm
from the wall
Right rear side
refrigerant pipe
hole ≥ 85