Inhaltsverzeichnis
Werbung
Hub-30_VP64-03
Hub-30_VP76-02
Hub-45_VP104-02
Kappe DF-380-00
Nabe DF-380-01
NabeDF112-02
PropNut DF-380-00
Puller DF-380-00
VP104_Flg-20-01_flat
VP104_Flg-26-01_flat
VP64_Flg-13-03_flat
VP64_Flg-18-03_flat
VP76_Flg-17-01_flat
VP76_Flg-22-01_flat
Tests carried out
None.
Marking of product
Manufacturer's name or trademark. Type number designation.
Periodical assessment
For retention of the Type Approval, a DNV GL surveyor shall perform an assessment after 2 years and
after 3.5 years to verify that the conditions of the type approval are complied with. A renewal
assessment will be performed at renewal of the certificate.
The objective of the Periodical Assessment is to verify that the conditions for the Type Approval are not
altered since the Type Approval Certificate was issued. The main scope of the Periodical Assessment will
normally include:
Verification of the Type Approval applicant's production and quality system w.r.t. ensuring
continued consistent production of the Type Approved products at the Type Approval applicant's
own premises and at other companies that are given the responsibility for manufacturing of the
products
Review of the Type Approval documentation and that this is still used as basis for the production
Review of possible changes to the design, the material and the performance of the product
Verification of the product marking
In cases where the Type Approved product is manufactured at other companies, the Periodical
Assessment shall verify that the Type Approval applicant has a quality control system for consistent
production at their licensees/subcontractors. Furthermore Periodical Assessment shall be carried out
randomly at these companies.
When a Type Approved product is manufactured at other companies, the Type Approval applicant takes
the sole responsibility for the conformity of the product to the applicable requirements.
END OF CERTIFICATE.
Form code: TA 251
F50_DF_GP80 Montageanleitung_Rev21.pdf
Stand: 11/01/2023
05a
04a
02/GL
01
01
04
00
00
2009-02-11
2009-04-15
2008-05-16
2008-05-16
2008-06-10
2008-06-25
Revision: 2020-02
Job Id:
Certificate No: TAM000017G
Hub-30 VP-64
Hub-30 VP-76
Hub-45 VP-104
Kappe DF-380
Nabe DF-380
Nabe DF-112
Prop.-Nut DF-380
Abzieher f. DF-380
Blade VP-104 20"
Blade VP-104 26"
Blade VP-64 13"
Blade VP-64 18"
Blade VP-76 17"
Blade VP-76 22"
www.dnvgl.com
262.1-034406-1
AP Approved
AP Approved
AP Approved
FI For Inf.
AP Approved
AP Approved
FI For Inf.
DI Discarded**
AP Approved
AP Approved
AP Approved
AP Approved
AP Approved
AP Approved
Page 4 of 4
17
Werbung
Inhaltsverzeichnis
