REV Ritter PROFILINE Bedienungsanleitung Seite 12

GB
INSTALLATION
• Installation may only be carried out by trained specialists in accordance with the applicable installation
instructions. For this purpose, consult a certified electrician (S8).
• ATTENTION!! Before installation, the power supply must be disconnected from the mains and secured against
being switched on again (S9).
• Please refer to the drawings for the installation steps.
CLEANING
• Disconnect the product from the power supply and secure the circuit from being switched on again.
• Allow the luminaire to cool down sufficiently!
• Before cleaning, unplug the product from the power point or disconnect it from the mains supply!
• Clean with a dry or slightly moist, clean, lint-free cloth and a mild detergent if required. Do not use cleaners that
contain abrasives or solvents.
MAINTENANCE
• Replace any damaged protective panels immediately (S13).
• Remove all dirt from the housing or protective panel immediately, as this can lead to overheating.
• The light source of this luminaire may only replaced by the manufacturer, an authorised service technician or a
similarly qualified person (S8).
• Change light source: First carry out installation steps 1-3 (A1+A2) and then change the LED tube. Finally, carry
out steps 8 and 9. Only the light sources specified in the technical data may be used for replacement.
1
WEEE DISPOSAL INFORMATION
According to the European regulations, used electrical and electronic equipment may no longer be put out into
unsorted rubbish. The symbol on the wheeled rubbish bin points out the necessity for separated collection. Help
us to protect the environment and ensure that this unit is put out in the appropriate systems for separate collection
once you do not use it any longer. DIRECTIVE OF THE EUOROPEAN PARLIAMENT AND COUNCIL of 4th July 2012
concerning used electrical and electronic equipment. (S14)
SERVICE
If you have any questions concerning our products or a complaint, then please go to www.rev.de to find out how
to make contact or how to organise a return. Alternatively, send an email to service@rev.de We'd like to point out
that we are unable to process any shipments which do not have a return number and will not accept them.
12
LED LED
Light source can be replaced
by end user!
1
Control gear not replaceable
2
(included in the light source)!
2