BDS Maschinen MAB 525 Originalbetriebsanleitung Seite 50

Preparations
KEYLESS quick-change drill chuck system
Adapter for thread taps
50
Inserting the tool
Push the KEYLESS quick-change drill chuck system (A) into
‹
the morse taper (3) of the machine.
Connect the lubricant line.
‹
Open the quick-change drill chuck system (A) by pushing up
‹
the sleeve and insert the tool into the chuck.
NOTE
► Insert the appropriate ejector pin before inserting the core
drill.
WARNING
Risk of injury from incorrectly inserted tool or tool mount-
ing .
► Check by briefly turning the tool whether the collet is en-
gaged.
Removing the tool
Open the quick-change drill chuck system (A) by pushing up
‹
the sleeve and pull the tool down out of the chuck.
Inserting the tool
Insert the thread tap into the appropriate adapter for thread
‹
taps (G).
Insert the adapter with the thread tap (G) into the KEYLESS
‹
quick-change drill chuck system (A).
Removing the tool
Open the quick-change drill chuck system (A) by pushing up
‹
the sleeve and pull the adapter for thread taps (G) down out
of the chuck system.
Pull the thread tap out of the adapter for thread taps (G).
‹
MAB 525