Atag DW7214SMB Gebrauchsanweisung Seite 170

Troubleshooting
Problem
Water remains in the
dishwasher.
Bad odour in dishwasher.
Grease deposits in the
dishwasher.
34
Possible causes
The filters are clogged.
The filters are not fitted correctly.
Debris in the drainage pump.
Drainage pump stop missing.
Kink in drainage hose.
Blocked drainage hose.
Dirt around the seals and in
corners.
Low temperature programs have
been selected for a prolonged
period.
Low temperature programs have
been selected for a prolonged
period.
Action
Clean the coarse and fine filters.
Check that the filters are fitted
correctly. See the chapter Care
and cleaning.
Clean the drainage pump. See
the chapter Care and cleaning.
Check that the yellow drainage
pump stop (on the right in the
bottom drain) is in place. See
the chapter Care and cleaning.
Check that the hose is free from
kinks and sharp bends.
Disconnect the drainage hose
where it connects to the sink
unit's water trap. Check that no
debris has fastened and that the
connection has an inner
diameter of at least 14 mm.
Clean with washing-up brush
and low foaming cleaner.
Run a program with a high
temperature once or twice a
month. Or run a self-cleaning
program. See Self-cleaning in
the chapter Using the
dishwasher.
Select a program with a high
temperature to dissolve grease
on very dirty dishes, such as
Intensive. Or run a self-cleaning
program once or twice a month.
See Self-cleaning in the chapter
Using the dishwasher.