Werbung
*Troubleshooting guide:
If there is no signal on the monitor (connected to the CSW320
receiver), please make sure that both devices (CSW320 transmitter
and receiver) are
(1) are switched to "splitter mode"
(2) have been paired with each other or repeat the process again.
** Instructions for pairing the devices (pairing mode)
(1) Set the toggle switches of TX and RX to SP mode and connect
the devices to the power supply.
(2) Connect the TX and RX via HDMI cable in the HDMI-IN jack. The
After that, the devices are connected to each other and the HDMI
cable can be removed again.
16
Werbung
