TMC Reef Flow 2.0 1000nano Installationsanleitung Seite 8

Press the Mode button to cycle the Reef Flow 2.0 nano through the following:
Green LED Flashing = Feed mode
Press and hold the mode button for approximately 2 seconds to enter Feed mode
to pause pump operation for 10 minutes. The controller will then start a 10 minute
countdown. When the 10 minutes have elapsed the pump will resume operation and
start pumping.
If you wish to restart the pump before the end of the 10 minute pause, press the mode
button again and the controller will display a RED flashing LED to indicate it is off and
then press the mode again and the pump will restart.
Red LED Flashing = OFF
Please note: When making any changes to the Wave Mode settings it is important that
you check and observe the effect any change made will have on your individual aquarium
and make sure that the wave intensity and frequency is suitable for your size aquarium and
its inhabitants.
Please note: In the event of a power cut, your Wave Mode settings will be saved.
OPERATION OF THE DC CONTROLLER
1
Red LED = Continuous Stream mode
Press the intensity button to increase/decrease the power
intensity of the pump
2
Green LED = Pulse mode
Press the intensity button to increase/decrease the frequency
of each Pulse wave.
3
Orange LED = Reef mode
Press the intensity button to increase/decrease the frequency
between each Reef wave.
8