TMC Reef Flow 2.0 1000nano Installationsanleitung Seite 6

The Reef Flow 2.0 nano pumps have been designed to simulate the natural currents found
within the reef environment. Using the supplied controller, you can choose from 3 wave
patterns and adjust the intensity and frequency of your selected wave, to ensure you can
create an environment appropriate for your particular tank and its inhabitants.
Interchangeable nozzle
1 2 3
Mounting magnet (internal)
6
1. Clean the glass where the pump is to be installed.
Caution: You must ensure that the pump is secured in your desired position before
operating.
2. Submerge the pump completely and then rotate it back and forth to allow any trapped
air to exit the pump impeller housing.
3. Locate the pump in a position at least 15-20cm below the water surface, ensuring
there is adequate space around the pump to avoid resonance, vibrations and substrate
being sucked into the pump. Also make sure the power cable will exit the aquarium in a
convenient place for connecting to the controller.
INTRODUCTION
4
7
INSTALLATION
6
Impeller
5
Mounting magnet (external)
Motor