Haier 7703422621 Bedienungsanleitung Seite 107

Pressing the "PROGRAMME SELECTION"
•
button until the
parameter is selected.
Parameter adjustment is performed by pressing
•
the "OPTIONS" and "EXTRA DRY" buttons to
change the value from "MEMO MODE ON" to
"MEMO MODE OFF" and vice versa.
Switch off the dishwasher by pressing the
•
"ON/OFF" button for 3 secs to confirm the new
setting.
To turn the alarm on again, follow the same
procedure.
ENABLING OR DISABLING DEMO MODE
(be used exclusively in stores)
Enabling
The dishwasher must ALWAYS be off before
you start this procedure.
1. Turn on the appliance using the ON/OFF
button.
2. Press the PROGRAMME SELECTION and
"DELAY START" buttons together for 5
seconds.
3. "DEMO MODE ON" will appear on the display.
4. If no button is pressed for 30 seconds, the
programme will start, simulating the start of
a wash programme.
The PROGRAMME SELECTION / OPTIONS /
DELAY START options are enabled, and by
pressing these buttons you can simulate the
product's functioning without starting a wash.
"MEMO FUNCTION"
Disabling "Demo mode"
WARNING
Once installed, if the appliance works
correctly but the wash cycle does not start
upon pressing the Start button, "Demo mode"
may not have been disabled.
The dishwasher must ALWAYS be off before
you start this procedure.
1. Turn on the appliance using the On/Off
button.
2. Press the PROGRAMME SELECTION and
"DELAY START" buttons together for 5
seconds.
3. "DEMO MODE OFF" will appear on the display.
4. Switch off the appliance.
EN 107