After Finishing Work - Seco GOLIATH GC 92 Bedienungsanleitung

6.2.2 After finishing work

Í SETTING UP THE MACHINE
After finishing mowing elevate the mowing deck to the highest position and disable the drive for the
mowing blades.
Turn off the ignition, step on the brake pedal and secure the machine in position with the parking brake.
Í CLEANING THE MACHINE
} Remove all dirt and grass remains from the surface of the tractor.
} Also remove grass, dust and other flammable materials from the edge of the exhaust.
Í CLEANING THE MOWING DECK
The mowing deck must be carefully cleaned after every use, namely the inside walls of the deck. Use
a scraper, spatula or a current of water for cleaning. Proper maintenance and treatment of the mowing
deck improves work quality and the machine's lifespan. Proceed as follows:
} Secure the machine against movement.
} Elevate the mowing deck to the transport position.
Machine GC 92 (mowing deck with a mowing coverage of 92 cm):
} Lift (tilt out) the protective metal cover on the right or left side of the chamber. Clean out the entire
area of the mowing deck.
} While cleaning also check the condition of the blades (
Machines GC 110 (riding mowers with a mowing coverage of 110 cm) and GC 132 (riding
mowers with a mowing coverage of 132 cm):
} Slide a hose of a suitable diameter on to one of the fittings on the mowing deck cover.
} Start the motor, engage the mowing deck and flush out the mowing deck with a current
of water for 10 minutes.
This flushing procedure needs to be performed at the end of every mowing session.
Avoid washing with water in the vicinity of electrical accessories on the control panel,
battery, etc.
Í WASHING THE MACHINE
We do not recommend cleaning the machine using pressurised water! If despite
this you do clean in this way, ensure that water does not enter the carburettor, air filter,
ignition, exhaust, battery and other electrical components.
Never direct the water current at the ball bearings (bearings in the blade holder, wheels)
or on to parts in which there is oil (oil filter, filler neck, etc.)
Before washing, park the machine on a suitable even surface.
} Plastic parts on the machine:
- clean using a sponge and soapy water
6.3.6).
91
6.2.2