Led Status - Stiga BT 40 Li 2.0 Gebrauchsanweisung

The lithium-ion battery does not have a charge
memory and can be recharged at any time.
1. Connect the charger to an AC outlet (1).
2. Put the battery pack (2) into the charger (3).
2
3
This is a diagnostic charger. The LED charger
lights (4) will light in a specific order to
communicate the current battery status.
DESCRIPTION
No battery
Battery charging
Fully charged
Overheated battery:
(remove for approx. 30 min.
to allow it to cool down)
Faulty battery
(remove and replace
with a new battery)
CHECKING THE CHARGER
If the battery pack does not charge properly:
• Check the output power with another tool.
Make sure that the outlet is not isolated.
• Check the charger contacts against short
circuit caused by debris or other materials.
If the battery is inserted into the charger
when it is hot or overheated, the LED LOAD
indicator light on the charger may light RED.
In this case, let the battery cool down out
of the charger for about 30 minutes.
NOTE If the battery and charger are not used
for a long period of time, remove the battery
from the charger and disconnect the AC outlet.
1
4

LED STATUS

○ Red
☼ Flashing green
● Green
☼ Flashing red
☼ Flashing red
IMPORTANT SAFETY INSTRUCTIONS
• KEEP THESE INSTRUCTIONS DANGER: TO
REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, IT IS IMPORTANT TO FOLLOW
THESE INSTRUCTIONS CAREFULLY.
• Before using the charger, check the
available voltage in each country.
6. CLEANING
To avoid the risk of fire
and electric shock:
• Do not use damp cloths or detergents
on the battery or the battery charger.
• Always remove the battery pack before
cleaning, inspecting or servicing the tool.
Clean the outside of the charger with a soft,
dry cloth. Do not rinse or clean with water.
7. DISPOSAL
Do not throw electrical equipment away
with domestic waste. In observance of
European Directive 2012/19/EC on
electrical and electronic equipment
waste and its implementation in accordance with
national regulations, electrical equipment that
has reached the end of its product life must be
collected separately and recycled in an
ecologically compatible way. If electrical
equipment is disposed of in dumps or in landfills,
hazardous substances can leak into the
groundwater and contaminate the food chain,
damaging your health and well-being. For further
information on the disposal of this product,
contact your dealer or a domestic waste
collection service.
At the end of their working life, dispose
of batteries paying due attention to the
environment. Batteries contain material
classified as hazardous for you and the
environment. They must be removed and
disposed of separately at a facility that accepts
lithium-ion batteries.
Separate waste collection of the
products and packaging used allows the
materials to be recycled and reused.
Reuse of recycled materials help to
prevent environmental pollution and reduces the
demand for raw materials.
EN - 4