Motor Protection; Technical Data - Olympia PS 21 CCD Bedienungsanleitung

If too much paper is inserted in the cutting unit, it will cause a jam.
Proceed as follows:
Push the sliding switch to the Rev / CD position.
-
The cutting unit runs backwards and pushes the excess paper back.
-
Reduce the quantity and slide the switch to Auto again. The cutting unit runs forward
-
again and the residue remaining is shredded.
If the backwards and forwards movement does not remedy the jam, pull out the mains
plug and remove the remaining manually from the cutting unit.
The motor switches off automatically in the event of overloading. Pull out the mains plug
from the socket and allow the motor to cool down to room temperature. Plug the mains
cable back in and then continue operation.
Caution: maintenance work may only be performed when the mains plug is pulled
out.
To ensure your shredder enjoys a long working life, we recommend to clear residual material
from the cutting units at regular intervals and apply special oil for paper shredders to the
cutting unit. This special oil is available from specialist dealers or directly from our service
centre in Hattingen. This will extend the service life of the device.
Model:
Power supply:
Cutting width of the paper slot:
Cutting width of the CD slot:
Cutting power:
Security level:
Max. power consumption:
Size (W x H x D):
Weight:
Operating cycle paper:
Operating cycle CD:
Clearing a jam

Motor protection

Notes on care and maintenance

Technical data

PS 21 CCD
220-240 V / 50Hz
220 mm
122 mm
5 DIN A4 sheets (80 g/m
1
0.6 A
310 x 190 x 296 mm
3.1 kg
2 min. on, 40 min. off
2 min. on, 40 min. off
12
2
), 1 CD, 1 credit card