Herunterladen Diese Seite drucken

Balluff BOS G05E-PS-ID10-PU-02 Bedienungsanleitung Seite 2

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Photoelectric Sensors
Nr. 916092
Ausgabe / Edition DE / EN / G14
Änderungen vorbehalten / subject to modification
COMPACT
Miniature optosensors
with integrated amplifier
Order code Part number code
BOS01W3
BOS G05E-PS-ID10-PU-02
BOS01W2
BOS G05E-NS-ID10-PU-02
BOS01W6
BOS M06M-PS-ID10-PU-02
BOS01W4
BOS M06M-NS-ID10-PU-02
BOS01W5
BOS M06M-PO-ID10-PU-02
BOS01W9
BOS R040M-PS-ID10-S49
BOS01W8
BOS R040M-NS-ID10-S49
www.balluff.com
REFLECTIVE BEAM SENSOR
Caution!
Do not use sensor
for personnel safety applications
Construction:
BOS G05E-..
BOS M06M-..
BOS R040M-..-S49
Technical Data:
light type
infrared 880nm
operating voltage
10...30 VDC reverse
polarity protection
frequency response
500Hz
current consumption
30mA
nominal sensing dist.
50mm*
BOS G05E
fixed
BOS M06M
fixed
BOS R040M
adjustable
operating temperature -10°C bis +55°C
stock temperature
-20°C bis +65°C
protection class
IP65
output current
100mA short circuit proof
function indicator
LED red
* on white non glossy paper (90% remission, 100x100mm)
Dimensions:
BOS G05E-..
44
Ø
5
BOS M06M-..
44
32
2,5
7
BOS R040M-..-S49
Installation advice:
In order to achieve the full performance range of these sensors according to their specified
data please ensure the accurate alignment of the sensor's light beam.
For reflective beam sensors of the COMPACT family with normal visible red or infrared light
please keep in mind that the light intensity distribution follows a Gaussian bell curve with the
maximum in the center of the spot and a steep descent towards the edges. In case of
unfavourable reflexions already the scattered light from the boundaries of a beam may be of
negative influence on the detection. Reflective beam sensors mounted close to each other
may generate optical crosstalk. Dead zones in front of the optics may appear.
A blinking function indicator indicates an instable working condition. Please check in such
cases if the sensor is polluted or mechanically misaligned.
General advice:
This sensor does not need an additional amplifier. To achieve the correct function of the device
please respect the specified electrical and mechanical limit values. Operation outside of
these limits may result in destruction of the sensor. In such case the specified warranty
becomes void.
COMPACT optosensors made by Balluff are tested according to DIN EN 60947-5-2 for fault-
free operation. Additionally it is recommended to connect the shielding of the supply cable to
PE (machine ground) for EMC protection.
Wiring scheme:
VDC
brown
output
black
GND
blue
PNP
8
2
VDC
brown
output
black
GND
blue
NPN
Z
L
Z
L

Werbung

loading

Diese Anleitung auch für:

Bos g05e-ns-id10-pu-02Bos m06m-ps-id10-pu-02Bos m06m-ns-id10-pu-02Bos m06m-po-id10-pu-02Bos r040m-ps-id10-s49Bos r040m-ns-id10-s49 ... Alle anzeigen