Optional Accessories - Makita RS001GM101 Betriebsanleitung

Adjusting 0°-cut accuracy
This adjustment has been made at the factory. But if it is
off, you can adjust it as the following procedure.
1. Slightly loosen the lever on the bevel scale plate.
2.
Make the base perpendicular to the blade using
a triangular rule or square rule by turning the adjusting
screw.
► Fig.29: 1. Triangular rule 2. Adjusting screw
3. Tighten the lever and then make a test cut to
check the verticalness.
OPTIONAL
ACCESSORIES
CAUTION:
These accessories or attachments
are recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or attachment
for its stated purpose.
If you need any assistance for more details regard-
ing these accessories, ask your local Makita Service
Center.
• Circular saw blade
• Offset wrench
• Rip fence (Guide rule)
• Front cuff 24
• Makita genuine battery and charger
NOTE: Some items in the list may be included in the
tool package as standard accessories. They may
differ from country to country.
14 ENGLISH