Layout; Technical Data; Before Starting The Equipment; Operation - EINHELL 42.585.70 Originalbetriebsanleitung

Anleitung_RT_MX_1600_E_SPK1__ 08.04.13 08:01 Seite 13

4. Technical data

Mains voltage:
Power input:
Idling speed: I 180-460/ II 300-700 min
Mixing tool mount:
Protection class:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 60745.
Vibration emission value a = 3.02 m/s
h
K uncertainty = 1.5 m/s 2
Additional information for electric power tools
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
n
order.
Service and clean the appliance regularly.
n
Adapt your working style to suit the appliance.
n
Do not overload the appliance.
n
Have the appliance serviced whenever
n
necessary.
Switch the appliance off when it is not in use.
n
Wear protective gloves.
n
230 V ~ 50 Hz
Residual risks
1600 W Even if you use this electric power tool in
accordance with instructions, certain residual
-1
risks cannot be rules out. The following hazards
M14
may arise in connection with the equipment's
II / construction and layout:
1. Lung damage if no suitable protective dust mask
4.6 kg
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or
is not properly guided and maintained.

5. Before starting the equipment

87,4 dB(A)
3 dB
Before you connect the equipment to the mains
98,4 dB(A)
supply make sure that the data on the rating plate
3 dB
are identical to the mains data.
Always pull the power plug before making
adjustments to the equipment.
Mixer assembly (Fig. 2):
First scew mixer part (6a) together with mixer part
2
(6b). Screw the mixer (6) into the mixer holder (5)
afterwards. Use the two spanners to do this. Use one
of the spanners (a) to hold the mixer holder (5) in
place and then use the second spanner (b) to tighten
up the mixer (6). Proceed in the reverse sequence to
undo the mixer.
is secure (pull the mains plug).

6. Operation

6.1 ON/OFF switch (Fig. 3/Item 1)
First fit a suitable mixing tool to the equipment
n
(see 5.)
Connect the mains plug to a suitable socket.
n
To switch on:
Press the ON/OFF switch (1)
Continuous operation:
Secure the ON/OFF switch (1) with the locking
button (2).
To switch off:
Press the ON/OFF switch (1) briefly.
GB
13