Veripart VPKK701 Benutzerinformation Seite 56

PROBLEM
The door does
- You tried to open the door
not open easily.
Water runs
- During the automatic defrosting
over the back
of the appliance
Water enters
- Products prevent water from entering
the appliance
- The water collection channel is
There is
- The door has been opened too often.
too much
- The door is not completely closed.
condensation
on the back
- The stored food was not packed.
wall of the
appliance.
There is water
- The defrost water collection channel
on the floor.
The
- The temperature is not set correctly.
temperature in
- The door is not closed properly.
the appliance is
too low/high.
- The temperature of the food in the
- Many products are stored at the same
- The door has been opened too often.
Poor cooling
efficiency
POSSIBLE CAUSE
immediately after closing.
process, icing thaws against the back
wall.
the water collection container.
blocked.
is not connected to the evaporator
container above the compressor.
fridge is too high.
time.
- Hot food has been placed inside
the appliance.
- The door does not close properly.
- The appliance is in direct sunlight
or near a stove or heater.
- The appliance is built into a
cabinet with little space around it.
- The temperature in the appliance
is set too high.
SOLUTIONS
- Wait a few seconds between
closing and re-opening the door.
- Wipe up the water with a soft
cloth.
- Ensure products do not touch the
back wall.
- Clean the water collection
channel.
- Only open the door if necessary.
- Make sure the door is completely
closed.
- Pack food in suitable material
before putting it in the appliance.
- Secure the defrost water
collection channel to the
evaporator container.
- Set a higher/lower temperature.
- Check whether something is
stopping the door from closing.
Remove or move possible
obstacles
- Allow the food to cool to room
temperature before preserving.
- Preserve fewer products at the
same time.
- Only open the door if necessary.
- Cool hot food before putting
it in the appliance.
- Check the door and door
rubbers and see if the door is
blocked.
- Place the appliance further
away from the heat source.
- Ensure sufficient distance to
ensure proper ventilation.
- Set the appropriate
temperature.
55