Programming; Buzzer And Leds - Vanderbilt Codelock V44 Duo Installations- Und Benutzerhandbuch

10

Programming

Before you start programming V44 Duo, make a note of the
codes to be used, to what timing group they should belong
and which relay output they should control. At the back of
this manual you will find a chart designed for this purpose.
Look at the chart as you program V44 according to the
instructions below.

Buzzer and LEDs

During programming you will be guided by the buzzer and
the LEDs.
In programming mode before a function is chosen:
Green and yellow LED flashes.
During programming: Yellow LED goes out. Green LED
is lit.
Correct instruction: Confirmed by a rising signal consisting
of two quick beeps.
Faulty instruction: Confirmed by a falling signal consisting
of two quick beeps.
NOTE! During programming mode, if a button is not
pressed within 20 seconds, the code lock goes back
to normal operation.
V44 Duo Installation & User manual