Step 3 Projecting; Selecting The Menu Language; Projecting An Image - Sony VPL-FHZ101L Kurzreferenz

Step 3

Selecting the Menu Language

The factory setting for the language for displaying
menus, messages, etc. is English.
To change the on-screen language, proceed as
follows:
1
Plug the AC power cord into a wall outlet.
2
Turn on the projector.
Press the / key on the main unit or the  key
on the Remote Commander.
3
Press the MENU key to display the menu.
If the display cannot be properly seen, adjust
the focus, size, and position of the projected
image (Page 47).
4
Select the menu language.
 Press the  or  key to select the Operation
( ) menu then press the ENTER key.
 Press the  or  key to select "Language
( )" then press the ENTER key.
 Press the /// key to select a
language, then press the ENTER key.
5
Press the MENU key to turn off the menu
screen.

Projecting an Image

The size of a projected image depends on the
attached lens or the distance between the
projector and screen. Place the projector so that
the projected image fits the screen size. For details
on projection distances and projected image sizes,
see "Projection Distance and Lens Shift Range" on
the Operating Instructions.
1
Plug the AC power cord into a wall outlet.
46
GB
Projecting
Projecting
2
Connect all necessary devices to the projector
(Page 44).
3
Turn on the projector.
Press the / key on the main unit or the  key
on the Remote Commander.
4
Turn on the connected device.
5
Select the input source.
Press the INPUT key on the projector or on the
Remote Commander to display the input
select window. Press the INPUT key repeatedly
or the / key to select an image to be
projected. The signal icon
right side in the input select window when a
*1
signal is input.
Also, you can select an input signal on the
Remote Commander.
*1: When INPUT F is input with the compatible
optional adaptor attached, the signal icon
always appears.
6
Change the computer screen output
destination to an external display.
How to change the output destination varies,
depending on the type of computer.
(Example)
7
Adjust the projected image (Page 47).
Turning Off the Power
1
Press the / key on the main unit or the 
key on the Remote Commander.
The shutdown process is started and the
projector enters the standby mode.
For long-term use, turn off the projector when
not in use.
2
Unplug the AC power cord from the wall
outlet.
appears on the