Before Loading And Plugging In The Wine Cooler - Pevino PNG122D Bedienungsanleitung

BEFORE LOADING AND PLUGGING IN THE WINE COOLER

Before using your wine cooler
• Remove the exterior and interior packaging.
• Before connecting the wine cooler to power source, let it stand upright for approximately 6 hours.
This will reduce risk of a malfunction in the cooling system from handling during transportation.
• Clean interior surface with lukewarm water by using a soft cloth.
• When replacing the illuminating lamp, please select a lamp similar to the original. Shut off the power
supply before replacing the lamp.
Installation of your wine cooler
• Place your wine cooler on a surface strong enough to support it when fully loaded. Level your wine
cooler by adjusting the levelling legs at the bottom front of the wine cooler.
• Place the wine cooler away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase energy consumption.
• Extreme cold ambient temperatures may also cause the unit not to perform properly.
• Avoid locating the unit in moist areas.
• Plug the wine cooler into a properly installed wall outlet. Any questions concerning power should be
directed toward a certified electrician or an authorized products service center.
Pay attention to this
• Store wine in sealed bottles.
• Do not overload the wine cooler.
• Do not open door unless needed.
• Do not cover shelves with aluminium foil or any other material that may prevent air circulation.
• Should the wine cooler be stored unused for a longer period of time, it is advised, after a good
cleaning, to leave the door ajar to allow air to circulate inside the cabinet in order to avoid possible
formation of condensation, mold or odours.
• The carbon filter should be cleaned and dried at least once a year.
4