Fein VersaMAG VISE Bedienungsanleitung Seite 21

Troubleshooting.
Malfunction
The movable clamping
jaw cannot be moved.
The magnetic holding
power is strongly
reduced.
Repair and customer service.
Renew stickers and warning indications on the product
when aged and worn.
After several hours of operation, the play in the mova-
ble clamping jaw can increase. In this case, tighten the
two screws on the bottom side of the movable clamp-
ing jaw so that the clamping jaw can be easily moved by
hand but does not tilt.
Do not remove the permanent mag-
WARNING
nets under any circumstances, as
they can cause injuries and contusions or bruises.
Have your product repaired only through a qualified
repair person and only using original replacement parts.
This will ensure that the safety of the product is main-
tained.
The current spare parts list of this product can be found
on the Internet under www.fein.com.
If required, you can change the following parts your-
self:
– Clamping jaws
Meaning
Clamping a workpiece is not pos-
sible.
The magnet is defective.
Corrective Action
Check the seating of the screws on the bottom
side of the clamping jaw. In this case, reduce the
tightening torque of the two screws.
Lubricate the two sliding surfaces of the vise reg-
ularly.
Please refer to a FEIN customer service agent.
Warranty and liability.
The warranty for the product is valid in accordance
with the legal regulations in the country where it is mar-
keted. In addition, FEIN also provides a guarantee in
accordance with the FEIN manufacturer's warranty dec-
laration.
The delivery scope of your product may include only a
part of the accessories described or shown in this
Instruction Manual.
Environmental protection, disposal.
Packaging, worn out products and accessories should
be sorted for environment-friendly recycling.
Accessories.
– Welding plate
en
21