Inhaltsverzeichnis
Werbung
EN
used. It must be remembered that grease is
deposited in the extractor when cooking,
whether it is switched on or not.
Cleaning of the extractor body
The use of warm (40ºC approx.) soapy water
is recommended. A cloth moistened in this
water is used for cleaning the extractor, paying
special attention to the grids. Afterwards, dry it
using a lint-free cloth.
Note:
Never use metallic scouring pads or
abrasive products that could damage
the surface.
Do not use scrapers with metallic
surfaces such as knives, scissors etc.
Activated charcoal filter
To install the charcoal filter, the motor
anchorage is made to coincide with
the anchor points of the activated
charcoal filter and turn it clockwise.
The carbon filter lasts from three to
six months depending on the
particular conditions of use.
The activated carbon filter can neither
be washed nor regenerated. Once it
is exhausted, it must be changed.
To replace exhausted filters with new
ones, withdraw the old one in the
reverse order to that of installation.
Changing Bulbs
Remove the filter support to acces
the bulbs.
Take care to disconnect the mains
beforehand and that the bulbs to be
replaced are not hot.
The maximum bulbs power is 40W.
Tecnical Information (Fig. 4)
Dimensions:
Width = 600 / 700 mm
Depth = 300 mm
Height = 184 mm
Electrical characteristics:
REFER TO RATING PLATE
Installation
To fix the extractor to the kitchen unit the
pattern on fig.3- 4 is used.
The lower part of the extractor must be
located at a minimum height of 60 cm
above the hob for electric cookers and 65
cm for gas cookers. If the instructions of a
gas cooker indicate a greater distance
these must be observed.
To achieve optimum performance the length of
the outlet hose should not exceed 4 meters, or
include more than two 90º angles (elbows).
Although venting to the outside is
recommended, activated carbon filters may be
used, which allow the gas to be returned to the
kitchen through the outlet pipe.
If you wish to exchange the front for one
matching the kitchen units, follow the following
instructions (Fig. 3):
*
Withdraw the movable group.
*
Remove the screws (T) that support
the front.
*
Install the new front fixing it with the
same screws that held the old one.
14
Werbung
Inhaltsverzeichnis
