Error Codes; Troubleshooting - Whirlpool WRD 6030 B Bedienungsanleitung

TROUBLESHOOTING

If the hob will not operate correctly, before calling the After-Sales Service,
refer to the Troubleshooting Guide to determine the problem.
• Read and follow the instruction s given in the section "Daily use"
• Check that the electricity supply has not been shut off.
• Dry the hob thoroughly after cleaning it.
• If the hob does not work following intensive use, the hob internaltemperature
is too high. Wait a few minutes until the hob cools down.
• If the hob will not operate correctly, before calling the After-Sales Service,
refer to the Troubleshooting Guide to determine the problem.
Error CODE
ER 03 & continuous
signal sound
ER 20
ER 21
ER 22
ER 31
ER 36
ER 40
ER 47
U 400
WARNING:
If the device is operated at maximum level for too long, it can
turn off automatically. This is an ordinary measure for safety of the device.
error Description
Constant use of buttons;
control unit is disrupted
after 10 seconds.
Flash fault.
Excessive temperature.
Key evaluation fault.
Control unit is turned
after 3.5 – 7.5 seconds.
Configuration data is
incorrect.
Temperature sensor
error.
Power supply is too
low to turn on the
appliance.
Communication error
between the electronic
board configuration and
the heaters.
Incorrect connection.
potential cause for
error
Water or cooking
utensils on the glass
over the control unit.
^ C error.
The ambient
temperature for
electronics is too high.
Short circuit or error in
detection of keys.
-
Short circuit or
electronic board turns
off.
Primary PTC is too hot.
No communication or
faulty communication.
Control unit is
connected incorrectly.
23
clearing error
Clean the operating
surface of the stove.
Replace the electronic
board.
Allow the cooking
surface to cool down.
Check the temperature
verification of the
control unit.
Replace the electronic
board.
New configuration is
required.
Replace the electronic
board.
Disconnect the stove
from power supply
system.
Make sure that the
connection cable is
connected correctly and
functionally.
Connect the stove to
correct mains voltage.