Samsung HW-Q600C Bedienungsanleitung Seite 17

LED Indicator Lights on the Rear of Subwoofer
LED
Blue
Red
Red and blue
NOTES
• Before moving or installing this product, be sure to turn off the power and disconnect the power cord.
• If the main unit is powered off, the wireless subwoofer will go into stand-by mode and the
STANDBY LED on the rear of the sub-woofer will turn red after blinking blue several times.
• If you use a device that uses the same frequency as the Soundbar near the Soundbar, interference
may cause some sound interruption.
• The maximum transmission distance of the main unit's wireless signal is about 10 m, but may vary
depending on your operating environment. If a steel-concrete or metallic wall is between the main
unit and the wireless subwoofer, the system may not operate at all because the wireless signal
cannot penetrate metal.
Status
Successfully connected
On
(normal operation)
Blinking Recovering the connection
Standby (with the Soundbar
main unit turned off)
On
Connection failed
Blinking Malfunction
ENG - 17
Description Resolution
-
Check if the power cable
attached to the main
Soundbar unit is connected
properly or wait about 5
minutes. If blinking persists,
try manually connecting the
subwoofer. See page 16.
Check if the power cable
attached to the main
Soundbar unit is connected
properly.
Connect again. See the
instructions for manual
connection on page 16.
See the contact information
for the Samsung Service
Centre in this manual.