Method 2. Connecting Using An Optical Cable - Samsung HW-Q600C Bedienungsanleitung

NOTES
• When you use Dolby Atmos®/DTS:X: If the input source is Dolby Atmos®/DTS:X, refer to "Output
specifications for the different sound effect modes" on page 13.
• When Dolby Atmos® is activated, "DOLBY ATMOS" appears in the front display.
• When DTS:X is activated, "DTS:X" appears in the front display.
• Configuring Dolby Atmos®/DTS:X on your BD player or other device.
Open the audio output options on the settings menu of your BD player or other device and make
sure that "No Encoding" is selected for Bitstream. For example, on a Samsung BD Player, go to
Home Menu → Sound → Digital Output and then select Bitstream (unprocessed).
• HDMI Pass-Through is that the Soundbar plays the audio from the source through its own speakers
and sends the unaltered video signal to a TV via the second HDMI cable.
Supported UHD Signals Specification (3840 x 2160p)
Frame rate (fps)
< 60
120
• Supported specification may vary depending on the connected external device or usage conditions.

Method 2. Connecting using an Optical Cable

HDMI TO TV
Bottom of the Soundbar
DIGITAL AUDIO IN (OPTICAL)
1. Connect the DIGITAL AUDIO IN (OPTICAL) port on the Soundbar and the OPTICAL OUT port on the
external device with the optical cable (not supplied), as shown in the figure.
2. Select "D.IN" mode by pressing the
3. The external device sound is output from the Soundbar.
Colour depth RGB 4:4:4
8 bit
10 bit
12 bit
8 bit
10 bit
(ARC)
Top of the Soundbar

YCbCr 4:4:4
O O
- -
- -
- -
- -
Optical Cable
(not supplied)

(Source) button on the top panel or on the remote control.
ENG - 26
YCbCr 4:2:2
O
O
O
-
-
OPTICAL OUT
BD / DVD player /
Set-top box /
Game console
D.IN
YCbCr 4:2:0
O
O
O
-
-