Ssd-Laufwerk (Volle Baulänge) - Dell OptiPlex Small Form Factor 7010 Bedienungsanleitung

2. Peel off the protection mylar on the thermal pad.
3. Align the notch on the M.2230 solid-state drive with the tab on the M.2 card slot on the system board.
4. Slide the M.2230 solid-state drive into the M.2 card slot on the system board.
5. Replace the screw (M2x3.5) to secure the M.2230 solid-state drive to the system board.
Next steps
1. Install the disk-drive cage.
2. Install the 3.5-inch hard drive
3. Install the 2.5-inch hard drive
4. Install the front bezel.
5. Install the side cover.
6. Follow the procedure in
SSD-Laufwerk (volle Baulänge)
Removing the M.2280 solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch hard drive
5. Remove the 3.5-inch hard drive
6. Remove the disk-drive
About this task
The following image indicates the location of the M.2280 solid-state drive and provides a visual representation of the removal
procedure.
Steps
1. Remove the screw (M2x3.5) that secures the M.2280 solid-state drive to the system board.
58 Entfernen und Installieren von vom Kunden austauschbaren Einheiten (CRUs)
if applicable.
if applicable.
After working inside your
Before working inside your
if applicable.
if applicable.
cage.
computer.
computer.