Overview Of The Components - BOMANN BS 9015 CB Bedienungsanleitung, Garantie

• Do not suck up liquids!
• Do not suck up hot ashes or pointed or sharp objects!
• Do not use the device in damp rooms!
• Never use without the filter. Check that the filter is inserted correctly!
• Hair, clothing and body parts away from the vacuum nozzle during
use!
• Keep the vacuum cleaner away from sources of heat like radiators,
ovens, etc.!

Overview of the Components

1 Air slide
2 Telescopic suction pipe
3 Holder for accessories
4 Slide for telescopic suction pipe
5 Floor nozzle (with hook (not shown))
6 Lever for extending and retracting the brushes
7 On/off button
8 Suction control
9 Stowage clip
10 Cable-winding button
11 Power cord with plug
12 Cover for extraction filter
13 Dust bag filling display
14 Connection head of the vacuum hose
15 Hose connection
16 Opener dust bag compartment
17 Suction hose
Not shown:
Dual accessory (combined crevice and brush nozzle)
Start-up
• Insert the connection head of the suction hose into the
hose connector until it locks in place. To do so, please
press the buttons simultaneously. In order to release the
hose again, please press the buttons once more on the
connection head.
• Keep the buttons pressed down and then pull out the hose.
• Insert the vacuum tube into the handle if required.
• Then assemble the floor nozzle and/or the accessories.
Nozzle Attachment
Floor nozzle (5)
The floor nozzle features castors for easier movement.
You can clean smooth surfaces and carpets with the floor
nozzle.
• Adjust the brushes outwards or inwards using the lever (6).
Best use of the appliance depends on the texture of the floor
covering. We recommend the following use:
• Use without brushes:
For vacuuming floor coverings with a deep pile
• Use with brushes:
For vacuuming smooth floors and carpets with a shallow
pile
Crevice and jointed nozzle
For vacuuming upholstery, curtains and in corners and crevices
etc.
NOTE: "2-in-1" nozzle:
When this is folded together it can be used as a groove
nozzle. If you would like to use the brush nozzle, pull the
brush section in the direction of the arrow until it locks in
place.
To detach the nozzle attachments from the suction pipe, pull
them off by turning them slightly.
Telescopic suction pipe
The length of the telescopic suction pipe can be adjusted
individually:
1. Loosen the locking mechanism by sliding
and holding the button (4) in the direction
of the arrow marking.
2. Extract one tube from the other to the
desired length.
3. Release the button in order to lock the
connection.
Mains cable
Pull the mains cable from the cable compartment.
31