Before Use
-Disassembly and assembly of the parts-
Disassembling/Assembling attachments
●
The following steps show how to disassemble/assemble attachments, using the juice attachment as
an example.
The frozen attachment can be disassembled/assembled in the same method.
To disassemble
1
Remove the
from the motor
housing.
2
attachment.
●
Squeezing screw comes out with it.
Squeezing
screw
(
Frozen
attachment
3
Remove the parts.
Filter
(
Frozen
attachment
Rotating
brush
GB12
1
Make sure the gasket, rubber
plug and rubber brushes are
in place correctly.
●
Gasket is located in the juicing bowl.
Top view
●
Rubber plug is located outer bottom.
Push it in until
no gap.
)
Outer bottom view
●
Rubber brushes are located on side of the
rotating brush.
See page GB19 for how to install the gasket,
rubber plug and rubber brushes.
●
The juicer may not work properly if
)
they are not assembled correctly.
To assemble
2
housing.
" mark on the motor housing and
" on the juicing bowl.
3
Attach the rotating brush and filter,
then set it on the motor housing.
" mark on the motor housing and
" mark on the juice attachment.
Top view
4
1 Insert the squeezing screw into the centre.
2 Rotate the squeezing screw and push it into
the hole until it stops.
●
The lid cannot be closed if the squeezing
screw is not pushed down sufficiently.
●
Be careful not to get your finger clamped in
the gap between the squeezing screw and
the filter.
(
)
Frozen
attachment
①
●
②
●
GB13