FUAVE ACB14K22 Betriebsanleitung Seite 33

Mode
With this you select a particular function: automatic, cooling, fanning or
dehumidifying� Every time you press the button, you change the function;
the light on the control panel shows which function is active�
The fan is set automatically�
Cooling
Press the Mode button until the function light 'Cool' comes on, press the
+ and – buttons to set the desired room temperature (17°C – 31°C)� Using
the FAN SPEED button on the remote control, you can set the fan speed to
HIGH or to LOW�
Fanning
Press on the Mode button until the 'Fan" function light comes on� Using
the FAN SPEED button on the remote control, you can set the fan speed to
HIGH or to LOW� The temperature cannot be set�
Dehumidifying
Press on the Mode button until the "Dry" function light comes on�
The fan speed and temperature cannot be set� The fan starts automatically
on LOW speed �
Temperature
With this, you set the desired room temperature in steps of 1°C (from 17°C
to 31°C)� The control system can show temperatures in °C and in °F� If the
temperature is shown is °F, then press both + and – buttons at the same
time for 3 seconds and the temperature will show °C again�
The LED display shows the set temperature of the cooling function� The
room temperature is shown at the dehumidifying and fanning functions� The
LED display also shows the following error and safety codes�
30