Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Mail Sets
Adjust the Separation of Special Feeders
4
Adjust the separation of special feeders as follows:
1.
Push knob A forward until it clicks.
2.
Turn knob A counter clockwise to open the separation gap.
3.
Place a document on the feeder tray and slide it into the system until it can go no
further.
4.
Turn knob A clockwise to get resistance.
5.
Move the document to and fro. The separation is adjusted correctly when a slight
resistance is felt on the document. Turn knob A counter clockwise again if the
resistance was set too high.
48
Werbung
Inhaltsverzeichnis
Fehlerbehebung
