Atos Unify OpenScape Desk Phone CP410 Installations- Und Kurzanleitung Seite 9

Important Notes
For safety reasons, the telephone can only be sup-
7
plied with power as follows:
• with the supplied original power supply unit,
• using a LAN with PoE (Power over Ethernet) which
supports the IEEE 802.3af standard
Never open the telephone. If you encounter any prob-
7
lems, contact your technical support.
Use only original accessories! Using other accessories
7
may be dangerous, and will invalidate the warranty,
extended manufacturer's liability and the CE mark and
other certifications.
RF Exposure Information (MPE):
This equipment should be installed and operated with mini-
mum distance 20cm between the radiator and your body.
Note (for USA only)
This device complies with part 15 of the FCC Rules. Opera-
tion is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, in-
cluding interference that may cause undesired operation.
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guaran-
tee that interference will not occur in a particular
installation. If this equipment does cause harmful interfer-
ence to radio or television reception, which can be deter-
mined by turning the equipment off and on, the user is en-
couraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and re-
ceiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Changes or modifications made to this equipment not ex-
pressly approved by the party responsible for compliance
may void the FCC authorization to operate this equipment.
This product is certified by a Nationally Recognized Testing
Laboratory (NRTL). This equipment also complies with Part
68 of the FCC Rules.
This equipment complies with FCC radiation exposure limits
set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance of
20cm between the radiator and your body. This transmitter
must not be co-located or operating in conjunction with any
other antenna or transmitter.
9