eta Pocky Bedienungsanleitung Seite 17

125.0 d
6.250 t
– You can put the container or bowl on the scale even before switching the
scale on. If you do so, the scale will automatically switch on with the value 0.
– In case that you put the bowl or container on the scale after it has been
switched on, press the Z/T button A4 (weight reset). The display will show
0. You can then proceed with the required weighing.
– Auto shut-off occurs if display shows ‚0' or shows the same weight
reading for 120 sec.
Operation
1) Place the scale on a suitable flat surface, open the lid A8 and turn
on by pressing the button A6.
2) Put the bowl (if you use one) on the scale before switching it on. Do
not put things you want to weight on the plate before you turn the
appliance on!
3) After the scale is switched on, first of all it is calibrated. When the display
shows 0..., the appliance is ready for weighing.
4) Use the UNIT A5 button to select the weighing units.
5) Put the food (object) in the middle of the weighing plate A3. When
weighing liquid or loose material (e.g. flour), place it in a bowl or container
prepared in advance (on the weighing plate A3). Then wait until the value
on the display becomes stable.
6) Turn off the scale by pressing button A6.
„TARE" function
To weigh different loads consecutively without removing loads from the
scale. Put first Load on the scale, get weight reading. Press A4 Z/T button to
reset the LCD reading to „0" before adding next load. The display will show
"TARE" in the upper left corner. Add another item and the display will read
the added weight. You can repeat this operation. If all products are taken
away from the weighing plate, a negative value will appear on the display.
dwt weight in pennies
ozt weight in troy ounces
Note
17
EN