Candy CIES55MCTT Bedienungsanleitung Seite 14

3.
Turn the whole cooktop off by touching the ON/OFF control.
4. Beware of hot surfaces
'H' will show which cooking zone is hot to touch. It will disappear when the
surface has cooled down to a safe temperature. It can also be used as an
energy saving function if you want to heat further pans, use the hotplate that
is still hot.
In case of a power interruption while "H" is on, please pay attention to not touch
the cooking surface even if "H" is no longer shown when the power is back.
Using the Power Management
Using power management you can set the total power to 2.5kW/ 3.0kW/ 4.5kW/
6.5kW and 7.4kW. The default total power setting is the maximum power level.
Setting the total power level to fit your requirement
1. Make sure the cooktop is turned off.
Note: you can only set power management when the cooktop is turned off.
2. Touch the button "Pause function" and hold for 5 seconds.
You can hear the buzzer beeps one time.
3. After you hear the beep, touch "+" and "-" button at the same
time and hold for 3 second, the timer indicator will show flashing previous total
power level, e.g. '2.5'. Touch and hold " +" and "-" for 1 second again to switch to
other power level, for example 3.0. When the power that you want is flashing,
touch the button "Pause function" and hold for 5 seconds. The buzzer will beep 10
times. It means you have finished the setting.
Note:
1. After step 2, you must touch the "+" and "-" within 3 seconds after you hear
the beep. Otherwise you will need to start again from step 2.
EN-13