GEV TITAN 180 LBB Bedienungsanleitung Seite 7

Troubleshooting – Practical tips
Problem
Motion detector switches
the light on too late
Motion detector fails to
achieve maximum range
Motion detector switches
light on constantly
or when not necessary
Fails to react to vehicles
Technical data
Field of detection
Range
Time adjustment
Twilight switch
Mains connection
Switching capacity
Protection type
Protection Class
Recommended fitting height
Subject to technical and design changes without prior notice.
Cause
• Field of detection setting
• Movement from the front
• Motion detector is mounted too low
• Difference in temperature between heat source and
surroundings is not big enough
• Constant thermal movement:
There are areas within detection range that are
not supposed to be monitored, e.g. footpaths, roads,
trees etc. Unexpected changes in heat sources
caused by storms, rain or fans.
The influence of direct / indirect sunlight.
• Vehicle has not warmed up
• Engine area is very well insulated
180°
freely adjustable from approx. 3 to 12 m
freely adjustable from approx. 10 secs. to 15 mins
freely adjustable from approx. 5 to 1,000 Lux
230 V ~, 50 Hz
max. 400 W LEDs, max. 400 W energy saving lamp, max. 800 W incandescent lamps
IP 44
II
2.5 m
Remedy
• Adjust field of detection
• Mount higher
7
by turning the sensor