Control Panel; Button Function - Franke FSW 918 BK/XS Bedienungsanleitung Und Installation

USE
-When power is supplied to the hood, LED A flashes for approximately 10 seconds; during this time the interface is not enabled.
-When the control panel functions are not active only button A can be seen. When this is pressed all the other commands become visible.
-The functions selected are shown by backlighting the button at maximum intensity, while the other buttons are lit at reduced intensity.
-If all the functions are off the panel will switch off after 30 seconds, or when button A is pressed.
Button Function
Press briefly to turn the motor Off.
A
Press and hold the button for approximately 4 seconds, with all the loads turned off
(Motor and Lights) and no alarms triggered, to turn the Remote control on/off.
The procedure can be activated with the door in any position.
Press briefly to activate speed one.
B
Press and hold for 2 seconds to activate the 24H function in which the motor turns
on at a speed that allows suction for 10 minutes every hour; at the end of the 24h
the function is deactivated.
To deactivate it, press and hold button B again for 2 seconds, or press button A or
button H.
Activates speed two.
C
Activates speed three.
D
Press briefly to activate speed four.
E
Press and hold for 2 seconds to activate Intensive speed. This speed is timed to run
for 6 minutes. At the end of this time the system will automatically return to the
speed set before.
Cannot be activated if the Delay or 24H functions are active.
It is disabled by pressing any of the Speed buttons or turning the Motor off.
Press briefly to turn the DELAY on/off, this enables automatic shutdown of the
F
Motor and the Lighting with a 30' delay.
Can be activated with the motor on (unless intensive or 24H is running).
Press and hold the button for approximately 4 seconds, with all the loads turned off
(Motor and Lights), to turn the Activated Charcoal Filter alarm on.
To turn it off, press and hold the button again for 4 seconds.
With the filter alarm triggered, press the button briefly to Reset the alarm.
These signals are only visible with the motor turned off and the control panel active.
The Reset is signalled by the fact that LED F turns off.
Press briefly to turn the Secondary Lights (spotlights) on and off at maximum
G
intensity.
The button is also active with the door closed.
Door Closed:
H
- Press and hold for approximately 2 Seconds to open the door, turn the motor on at
first speed and turn the Main lights (LEDs) on.
Door Open:
- Press briefly to turn the Main lights (LEDs) On or Off.
- Press for 2 seconds to turn everything off (Motor and Main lights) and close the
door.
EN

Control panel

Display
The LED on button A is on fixed (when the
motor is on)
The LEDs on buttons A and B flash twice to
indicate that the remote control is on;
The LEDs on buttons A and B flash once to
indicate that the remote control is off;
LED on button B is on fixed
LED on button B flashes (every 0.5 seconds
during the 10 minutes on and every 2 seconds
during the 50 minutes off)
LEDs on buttons C and A are on fixed
LEDs on buttons D and A are on fixed
LEDs on buttons E and A are on fixed
LED on button E on (flashes every second) and
LED on button A on fixed
LED on button F on fixed if the function is
activated
The LEDS on buttons F and B flash twice
The LEDS on buttons F and B flash once
After 100 hours operation the Led on button F
lights up continuously to indicate saturation of
the Metal Grease Filters.
After 200 hours in operation the Led on button
F flashes to indicate saturation of the Activated
Charcoal filters.
LED on button G is on fixed
LED on button H is on fixed when the main
lights are turned on.
2
28