hillvert HT-HPW-180 Bedienungsanleitung Seite 56

• Pour 1 tablespoon of fresh engine oil into the cylinder through the
spark plug hole and (with the ignition off) gently pull the starter tug
lever several times until resistance (compression) is felt to distribute
the oil in the cylinder.
• Reinstall the spark plug in the engine.
Replace the engine oil with fresh oil.
•
n) Every 100 working hours or six months (whichever comes first), remove
the spark plug and check the condition of its electrodes, and if necessary
clean the electrodes with a wire brush. Before reassembling the spark
plug, it is necessary to check the spark plug washer and the gap between
them and, if necessary, set the correct one. If the candle turns out to be
worn out, replace it with a new one, or a suitable replacement.
o) Change the gear oil in the pump mechanism every 100 operating hours.
Every once in a while you change the gear oil, you can flush the system
by pouring out the used oil and pouring purified kerosene into the system
first and running the unit for 10-15 seconds before pouring in fresh oil.
Then drain the kerosene and then pour in the fresh gear oil.
DISPOSAL OF WASTE APPLIANCES
At the end of its useful life, this product should not be disposed of with normal
household waste but should be taken to a collection point for the recycling of
electrical and electronic equipment. This is indicated by the symbol on the
product, operating instructions, or packaging. The materials used in this appliance
are recyclable according to their marking. By reusing, recycling, or applying other
forms of use of waste machines, you make a significant contribution to the
protection of our environment.
Your local administration will provide you with information about the appropriate
disposal point for used appliances.