hillvert HT-HPW-180 Bedienungsanleitung Seite 55

• Run the engine for a few minutes to warm up the oil - warm oil is
thinner and drains faster.
ATTENTION: oil in an engine that has recently been running may be
hot - risk of burns!
• Place the device on an even and stable surface.
Place a waste oil container under the oil drain plug.
•
• Unscrew one of the oil filler plugs.
Unscrew the oil drain plug carefully.
•
• Wait until the used oil finishes draining while assessing the condition
of the plug gasket - if it is damaged or worn, then replace it with a
new one.
• Screw the oil drain plug back on.
Fill up with fresh oil through the filler cap.
•
m) If the device is not used for more than one month:
empty the fuel from the tank and fuel system by unscrewing the
•
precipitation filter (photo below) or removing the fuel hose from the
carburetor, or adding a stabilizer to the fuel (follow the additive
manufacturer's instructions).
ATTENTION: never keep fuel in the unit longer than allowed by the
manufacturer of the added stabilizing additive!
• Remove the ignition wire pipe from the spark plug and unscrew the
spark plug: