Voice Function - Jimmy HW9 Pro Gebrauchsanweisung

Brushroll self-cleaning and drying
function
Before self-cleaning, please empty the dirty water tank
first, then fill the clean water tank with water and place
the machine on the charging base. In the charging
mode, long press the mode button for 3 seconds to
enter the self-cleaning mode, accompanied by voice
reminding. When the display screen shows "
symbol, it will automatically enter the drying mode and
start charging. In the process of self-cleaning or drying,
press the handle on/off button or mode button to exit
the self-cleaning or drying mode and product change to
charging state.
Notes:
1.Before self cleaning, please make sure that the
brushroll window is slid up.
2.Drain the dirty water tank before and after self-
cleaning.
3.When the power is lower than 10%, the machine
cannot enter the self cleaning mode. After charging for a
period of time, it can run self cleaning mode.(Fig 12)
Clean water tank empty indicator
When the clean water tank is short of water, the
machine can still be used normally. The voice reminds
"No clean water, please fill water". The display "
flashes until the machine is turned off or the screen is turned off in the upright state to remind the user to add
water to the clean water tank.
When using the self clean mode, if it is detected that there is no water in the clean water tank, the voice
reminds "No clean water, please fill water". The self cleaning will be stopped and automatically enter the
charging mode after the countdown of 10 seconds ends. The display "
off the charging base, or reenters self clean mode or display screen is turned off after charging completed.
Note: When adding clean water, you can add the JIMMY cleaning solution equipped with the product, the ratio
is about two bottle of cleaning solution to one full water tank, the water temperature cannot exceed 40°C.
Fill up clean water tank
Fill up clean water tank: After removing the clean water tank, open the water filling plug, turn it to the side
to expose the water inlet hole, pour clean water and cleaning solution in, and then plug back to the original
position and reinstall the clean water tank to floorhead. (Fig 13)
Dirty water tank full indicator
When the upright vacuum cleaner detects that the dirty water tank is full, the machine will stop and give a
voice reminder. The display "
dirty water tank and put it back.
When it is detected that the dirty water tank is full in self clean mode, the machine will stop working and give a
voice reminder. The display "
dirty water tank is cleaned. Please clean the full dirty water tank and put it back.

Voice function

The voice of the new machine is turned on by default, press the mute button to turn off the voice function;
press the mute button again to turn on the voice function. (Fig 14)
6
"
"
" flashes and the screen will turn off after 10 seconds. Please clean the full
" flashes until the whole machine is removed from the charging base or the
缺翻译
充电模式 自清洁模式
12
13
14
" flashes until the machine is taken
烘干模式
Mute button
6