Atag WU9011RM Anleitung Seite 63

MAINTENANCE
2 1
Removing cassette filter
1 Switch off the motor and lighting.
2 Pull the edge extraction panel carefully out of the magnetic seal.
Tilt the edge extraction panel downwards.
3 Open the filter's access latch. Support the filter with your hand.
4 Remove the filter from the hood.
Cleaning
The filters can be cleaned in the dishwasher. Allow the filters to drain
well before replacing.
The filters can also be cleaned by hand.
Clean the filters in soapy water with washing up liquid and rinse. Allow
the filters to drain well. See page 13 for instructions. The underside of
the cooker hood can be cleaned with a mild cleaning agent and a damp
cloth. Dry off with a paper towel.
Replacing cassette filter
The filter should be placed with the locking mechanism on the front.
Open the filter access latch. The notches at the front of the filter will then
slot in. Hold the access latch in this position when placing the filters.
1 Slot the notches at the back of the filter in the specially designed
opening of the cooker hood.
2 Tilt the filter upwards.
3 Release the filter access hatch. The notches at the back of the
filter will extend outwards and slot into the specially designed
openings of the cooker hood.
The filter is now in position again.
4 Press the edge extraction panel firmly in the magnetic seal again
(you will hear a click)
The edge extraction panel can be removed for cleaning.
EN 15