Charging Of The Helicopter - ACME manCopter Anleitung

Charging Socket / On/Off- Switch
Landing Gear
Please note!
Never fly close to other people! Danger of injury!
Don´t fly if obstacles complicate flying!
Don´t fly if it´s too windy. Close windows and doors!

Charging of the helicopter

The helicopter gets charged by the charging lead of the controller.
Switch OFF the helicopter and the controller!
Connect the charging lead under the coverage of the controller with the socket marked "CHA"
at the helicopter. Now switch on the controller.
The procedure is displayed by the green LED and is finished when the light turns off.
Charging takes about 30-40 minutes. Please note that only full batteries can charge the
helicopter.
If charging is finished earlier, the batteries in the controller are weak and have to be
replaced! The controller LEDs starts blinking when to low to charge!
Preparation
Place the helicopter on a plain surface, so that the tail rotor points into your direction. Switch
on the helicopter. Check if any obstacles could affect fly. Step back for at least one meter and
then switch on the controller.
First pull the gas stick down, then up and again down – now the helicopter is ready for take
off!
Flying
The range of the controller is about 10m, but can be interfered by sun- or strip lights.
Avoid flying directly under the ceiling or crashing against walls – this causes crashes and can
damage the helicopter. Optimal flying at about 1m.
Main rotor A
Stabilizer
Main rotor B
IR-sender
On/Off Switch
Charging LED
Gas Stick Channel Switch Control Stick
Cover
Charging Lead
5
Tail Rotor
Trimming wheel
Power LED