Replacing Filters; Consumables; Maintenance - Hedson Drester ACE DG2A Bedienungsanleitung

30 seconds to improve the process. Total
coagulation time is 3–4 minutes.
7. Close the valve for the agitator
)
.
Filtration
1. Open the drain valve at the bottom of the
manual sink and drain the sink completely into
the filter.
2. Clean the inside of the manual sink thoroughly
with the brush (with recycled water). Any
remains of residual flocks should be completely
drained into the filter.
3. Close the drain valve.

21. REPLACING FILTERS

Note! Only use original DRESTER main filters
and prefilters, since these are approved by paint
manufacturers.
4
18
Drester ACE Drester ACE
Item
1
(or mixer
2
3
4
The prefilter (1) collects most of the coagulated
sludge, while the main filter (2) collects finer paint
particles.
Remove the paint residues from the prefilter. Once
the paint residues are completely dry, they are
easy to remove. If the paint residues are removed
after each coagulation process, the prefilter can be
reused up to 10 times.
The main filter will gradually become blocked
after trapping the finer paint particles. In general,
the main filter can be used for up to 5 coagulation
processes. However, the main filter must be
changed every 1–2 months to prevent bacterial
growth.
Note! Coagulation paint residue must be handled
according to regulations from the appropriate
authority. Information from the paint supplier may
be required.

22. CONSUMABLES

Units suitable for waterborne paint, that is,
DRESTER ACE DG2A/DI2A, DG2C/DI2C, DG3C/
DI3C, and DG4C/DI4C, can be delivered with main
filter, prefilter, DRESTER AQUASOLVE waterborne
solvent and DRESTER FLOCCULATION POWDER.
All consumables can be ordered from your local
representative or Hedson Technologies.
1

23. MAINTENANCE

2
Every week
• Remove the strainers at the bottom of the
automatic washers and clean them.
Note! Remember to refit!
3
Part
Prefilter
Main filter
Filtrate container
Strainer on suction pipe
231721 Rev. 1 2022-12-01 231721 rev.1 2022-12-01